If you have been reading about LC-MS and want a single page that covers the useful parts, this is it: definitions, context, how it is studied, and the questions that come up repeatedly.
Updated 2025-08-06. Numbers and descriptions here follow the published literature rather than marketing material.
Peptide purity specifications describe the minimum acceptable result from a defined test. A certificate of analysis may list HPLC purity, mass spectrometry identity, appearance, and counterion content. Specifications are method-dependent, so a value obtained with one gradient or wavelength may differ from another. For research use, common thresholds include 95% and 98% by RP-HPLC, but the appropriate limit depends on the application. The specification should always name the analytical method and acceptance criterion.
Quality control includes system suitability, blank injections, and reference standards. System suitability checks column performance and retention time reproducibility, while blank runs detect carryover or mobile-phase contaminants. Reference standards help calibrate retention time and detector response. Without these controls, a purity value is difficult to compare across laboratories or over time. Documentation of instrument settings and integration parameters is also part of quality control, and acceptance criteria should be set before samples are analyzed.
Reversed-phase high-performance liquid chromatography (RP-HPLC) is widely used to estimate peptide purity. Separation depends on interactions between peptide residues and a hydrophobic stationary phase, with gradients of water and organic solvent. Ultraviolet detection near 214 nm responds to the peptide backbone and to many related impurities. The resulting chromatogram is often expressed as area percent, which reports the proportion of peak area assigned to the main component. Different columns, gradients, and wavelengths can produce different purity values for the same material.
Mass spectrometry provides complementary information about molecular identity and certain impurities. Electrospray ionization and matrix-assisted laser desorption/ionization are common ionization techniques for peptides. A measured mass close to the expected value supports correct sequence length and modifications, while extra mass signals can reveal truncations, adducts, or incomplete deprotection. Mass spectrometry alone is not a quantitative purity assay, because ionization efficiency varies between compounds. Coupling liquid chromatography to mass spectrometry links retention time with mass and helps assign peaks that ultraviolet detection records.
| Property | Value | Notes |
|---|---|---|
| Common purity specification | ≥95% by RP-HPLC | Threshold varies by application and supplier |
| Identity confirmation | Mass spectrometry | Expected versus observed molecular mass |
| Appearance | Lyophilized powder | Visual check for color and uniformity |
| Typical storage temperature | -20 °C or lower | Protect from moisture and repeated freeze-thaw |
| Counterion example | Trifluoroacetate or acetate | Residual counterion measured separately |
Mass spectrometry provides complementary information by measuring molecular mass. Electrospray ionization or matrix-assisted laser desorption/ionization can confirm the expected peptide mass and reveal related impurities with different masses. It does not directly quantify all species because ionization efficiency varies. When coupled to liquid chromatography, LC-MS can assign masses to chromatographic peaks. This helps distinguish target peptide from truncation, oxidation, or deletion products. Mass accuracy and resolution determine how confidently a mass can be matched to a proposed structure.
Other methods address specific purity concerns. Amino acid analysis gives compositional data after hydrolysis, while capillary electrophoresis separates by charge-to-mass ratio. Karl Fischer titration measures residual water, and gas chromatography can detect residual solvents. Nuclear magnetic resonance can identify organic impurities but is less sensitive for trace levels. No single test covers all possible impurities, so purity testing usually combines orthogonal methods and reports the conditions used. The choice of methods is guided by the impurity classes of interest.
Handling practices reduce the risk of contamination and degradation. Hygroscopic peptides should be equilibrated to room temperature before opening to prevent condensation on the powder. Weighing and reconstitution in a controlled environment limit exposure to moisture and airborne particles. Aliquotting reconstituted solutions avoids repeated freeze-thaw cycles that can cause aggregation or precipitation. When a purity specification is not met, investigation may consider synthesis byproducts, purification losses, storage conditions, and analytical variability rather than a single cause.
Peptide purity can change during storage, handling, and reconstitution, and lyophilized peptides are generally more stable than solutions because water promotes hydrolysis and aggregation. Residual moisture, oxygen, and trace metals can accelerate degradation even in solid form. Temperature fluctuations during shipping may cause condensation and local moisture uptake. Quality control therefore includes appearance, water content, and analytical testing before and after storage challenges. Peptides containing cysteine, methionine, or tryptophan are especially susceptible to oxidation, while asparagine and glutamine residues can deamidate under neutral or alkaline conditions.
Analytical quality control compares a stored sample against a baseline profile. Reverse-phase chromatography remains common, but stability studies may also use mass spectrometry to detect oxidation, deamidation, or truncation products. Accelerated aging at elevated temperature can reveal degradation pathways, although extrapolation to room temperature is uncertain. Forced degradation studies expose peptides to heat, light, acid, base, and oxidants to identify likely breakdown products. Documentation should record lot number, storage history, and the exact method used for each measurement.
A 2018 review found e-cigarette vapor containing reactive oxygen radicals seem to be similar to levels in traditional cigarettes. Glyoxal and methylglyoxal found in e-cigarette vapors are not found in cigarette smoke.
deoxyribonucleotide A nucleotide containing deoxyribose as its pentose sugar component, and the monomer or subunit used to build deoxyribonucleic acid (DNA) molecules. Deoxyribonucleotides canonically incorporate any of four nitrogenous bases: adenine (A), guanine (G), cytosine (C), and thymine (T). Compare ribonucleotide.
Fox, Sidney W. (1957). Introduction to protein chemistry. New York: Wiley. Fox, Sidney W. (1965). The origins of prebiological systems and of their molecular matrices. New York: Acad. Pr. Fox, Sidney W.; Duane L Rohlfing, Aleksandr Ivanovich Oparin (1972). Molecular evolution: prebiological and biological. New York: Plenum Press. Fox, Sidney W., Klaus Dose; with a foreword by A. Oparin (1977). Molecular evolution and the origin of life (Rev. ed. ed.). New York: M. Dekker. Fox, Sidney W. (1984). Individuality and determinism: chemical and biological bases. New York: Plenum Press. Ho, edited by Mae-Wan; Fox, Sidney W. (1988). Evolutionary processes and metaphors. Chichester: Wiley. pp. 333. ISBN 0-471-91801-6. Fox, Sidney W. (1988). The emergence of life: Darwinian evolution from the inside. Basic Books.
Sources: en.wikipedia.org
=== Other methods === Electrology Epilation Laser hair removal Lifestyle change, including reducing excessive weight and addressing insulin resistance, may be beneficial. Insulin resistance can cause excessive testosterone levels in women, resulting in hirsutism. Shaving Waxing
Type 1 and 2 5α reductase enzymes are present at pilosebaceous units in papillae of individual hair follicles. They catalyse formation of the androgens testosterone and DHT, which in turn regulate hair growth. Androgens have different effects at different follicles: they stimulate IGF-1 at facial hair, causing hair regrowth, but stimulate TGF β1, TGF β2, dickkopf1 and IL-6 at the scalp, causing hair follicle miniaturisation. Female androgenic alopecia is characterized by diffuse crown thinning without hairline recession, and like its male counterpart rarely leads to total hair loss. Finasteride and minoxidil are usually first line therapy for its treatment. Other options include topical or systemic spironolactone or flutamide, although they have a high incidence of feminising side effects and are better tolerated in female androgenic hair loss. More advanced cases may be resistant or unresponsive to medical therapy, however, and require hair transplantation. Naturally occurring units of one to four hairs, called follicular units, are excised and moved to areas of hair restoration. These follicular units are surgically implanted in the scalp in close proximity and in large numbers. The grafts are obtained from either Follicular Unit Transplantation (FUT) – colloquially referred to as "strip harvesting" – or Follicular Unit Extraction (FUE). In the former, a strip of skin with follicular units is extracted and dissected into individual follicular unit grafts. The surgeon then implants the grafts into small incisions, called recipient sites.
== Society and culture == The scalp plays an important role in the aesthetics of the face. Androgenic alopecia, or male pattern hair loss, is a common cause of concern to men. It may be treated with varying rates success by medication (e.g. finasteride, minoxidil) or hair transplantation. If the scalp is heavy and loose, a common change with ageing, the forehead may be low, heavy and deeply lined. The brow lift procedure aims to address these concerns. Scalping is the act of removing a human scalp, usually with hair, as a trophy. Often associated with the history of North America, scalping developed independently on multiple continents and dates back to antiquity.
== References == This article incorporates text from a publication now in the public domain: Chisholm, Hugh, ed. (1911). "Chevreul, Michel Eugène". Encyclopædia Britannica (11th ed.). Cambridge University Press.
Sources: en.wikipedia.org
Sulfur (specifically octasulfur, S8) is used in pharmaceutical skin preparations for the treatment of acne and other conditions. It acts as a keratolytic agent and also kills bacteria, fungi, scabies mites, and other parasites. Precipitated sulfur and colloidal sulfur are used, in form of lotions, creams, powders, soaps, and bath additives, for the treatment of acne vulgaris, acne rosacea, and seborrhoeic dermatitis. Many drugs contain sulfur. Early examples include antibacterial sulfonamides, known as sulfa drugs. A more recent example is mucolytic acetylcysteine. Sulfur is a part of many bacterial defense molecules. Most β-lactam antibiotics, including the penicillins, cephalosporins and monobactams contain sulfur.
Most of the Afghan population was already going hungry at the time of the attacks. In the aftermath of the attacks, tens of thousands of people attempted to flee Afghanistan due to the possibility of military retaliation by the U.S. and Pakistan, already home to many Afghan refugees from previous conflicts, closed its border with Afghanistan on September 17, 2001. Thousands of Afghans also fled to the frontier with Tajikistan but were denied entry. The Taliban leaders in Afghanistan pleaded against military action, saying "We appeal to the United States not to put Afghanistan into more misery because our people have suffered so much", referring to two decades of conflict and the humanitarian crisis attached to it. All United Nations expatriates had left Afghanistan after the attacks and no national or international aid workers were at their post. Workers were instead preparing in bordering countries like Pakistan, China and Uzbekistan to prevent a potential "humanitarian catastrophe", amid a critically low food stock for the Afghan population. The World Food Programme stopped importing wheat to Afghanistan on September 12 due to security risks.
=== Immunostimulatory CpG motifs === Plasmid DNA itself appears to have an adjuvant effect on the immune system. Bacterially derived DNA can trigger innate immune defence mechanisms, the activation of dendritic cells and the production of TH1 cytokines. This is due to recognition of certain CpG dinucleotide sequences that are immunostimulatory. CpG stimulatory (CpG-S) sequences occur twenty times more frequently in bacterially derived DNA than in eukaryotes. This is because eukaryotes exhibit "CpG suppression" – i.e. CpG dinucleotide pairs occur much less frequently than expected. Additionally, CpG-S sequences are hypomethylated. This occurs frequently in bacterial DNA, while CpG motifs occurring in eukaryotes are methylated at the cytosine nucleotide. In contrast, nucleotide sequences that inhibit the activation of an immune response (termed CpG neutralising, or CpG-N) are over represented in eukaryotic genomes. The optimal immunostimulatory sequence is an unmethylated CpG dinucleotide flanked by two 5’ purines and two 3’ pyrimidines. Additionally, flanking regions outside this immunostimulatory hexamer must be guanine-rich to ensure binding and uptake into target cells. The innate system works with the adaptive immune system to mount a response against the DNA encoded protein. CpG-S sequences induce polyclonal B-cell activation and the upregulation of cytokine expression and secretion. Stimulated macrophages secrete IL-12, IL-18, TNF-α, IFN-α, IFN-β and IFN-γ, while stimulated B-cells secrete IL-6 and some IL-12.
This mechanism is akin to the role of lysine in bacterial cell walls, in which lysine (and meso-diaminopimelate) are critical to the formation of crosslinks, and therefore, stability of the cell wall. This concept has previously been explored as a means to circumvent the unwanted release of potentially pathogenic genetically modified bacteria. It was proposed that an auxotrophic strain of Escherichia coli (X1776) could be used for all genetic modification practices, as the strain is unable to survive without the supplementation of DAP, and thus, cannot live outside of a laboratory environment. Lysine has also been proposed to be involved in calcium intestinal absorption and renal retention, and thus, may play a role in calcium homeostasis. Finally, lysine has been shown to be a precursor for carnitine, which transports fatty acids to the mitochondria, where they can be oxidised for the release of energy. Carnitine is synthesised from trimethyllysine, which is a product of the degradation of certain proteins, as such lysine must first be incorporated into proteins and be methylated prior to being converted to carnitine. However, in mammals the primary source of carnitine is through dietary sources, rather than through lysine conversion. In opsins like rhodopsin and the visual opsins (encoded by the genes OPN1SW, OPN1MW, and OPN1LW), retinaldehyde forms a Schiff base with a conserved lysine residue, and interaction of light with the retinylidene group causes signal transduction in color vision (See visual cycle for details).
Antipsychotics are generally a first-line treatment for delirium; however, when delirium is caused by alcohol or sedative hypnotic withdrawal, benzodiazepines are a first-line treatment. There is some evidence that low doses of benzodiazepines reduce adverse effects of electroconvulsive therapy.
Sources: en.wikipedia.org
It is a document reporting test results for a specific lot, often including appearance, HPLC purity, mass identity, and storage conditions. It should identify the analytical method and acceptance criteria. The certificate describes the tested sample, not necessarily every vial.
Not necessarily. HPLC purity reflects relative ultraviolet absorbance under one set of conditions. A peptide with high area percent may still contain a biologically active impurity or have poor solubility.
Comparisons require the same method, wavelength, gradient, and integration rules. Results from different laboratories may not be directly comparable. Reporting the method alongside the value is essential for interpretation.
RP-HPLC purity is the relative area of the main peptide peak compared with the total integrated peak area. It reflects ultraviolet-absorbing species under one set of separation conditions. It does not identify every impurity or measure biological activity.